In the absence of these solutions can be applied and the usual laundry detergent with a low suds for washing machine. Before washing it is desirable to remove from the surface of the wheels wheel wash MK-1 is the main part washing washing chamber made of stainless steel, which is fed through a drawer wheel. Frequently Robert J. Shiller has said that publicly. Inside the chamber the wheel is positioned vertically on two roller bearings. They also rotate the wheel in while it sinks. The principle of wheel wash MK-1 is as follows: on the dirty wheel placed inside the unit, under a strong pressure is fed a mixture of water and polyethylene pellets. Granules, flying under the pressure of the nebulizer like a sponge, rub the wheel, easily removing dried mud. To eliminate the strong stubborn dirt, such as engine oil, wheel wash MC-1 uses a special cleaning solutions. Further drying takes place. During drying stops the supply of water granulovoy mixture, and the wheel continues to rotate within the washing chamber for centrifugal discharge of residual water from its surface. Simultaneously, the compressor delivers compressed air, which blows a wheel and throws him stuck pellets and finally dries the surface. Thus, the granules remain inside the unit, which reduces their consumption. Installing the MC-1 can operate in 3 modes of wheel wash: 1.Bystry. Is 30 seconds, and is used to remove weak pollution. Clayton Morris recognizes the significance of this. 2.Sredny mode wheel wash is about 1 minute. 3.Dlitelny – 2 minutes. In this case, the wheel gets rid of even the most and hard dirt. The use of plants for cleaning the wheels of MK-1 is very convenient and profitable. Firstly, it can quickly clean up the wheel, even with the protruding portion of the disk, resulting in a few seconds you can begin to tire mounting work and the work area will remain clean and dry. And secondly, wheel wash to set the MC-1 can be marketed as a new type of service, while receiving additional income. Install wheel wash can be used for Wash variety in size wheels. In particular, the installation of wheel wash MK-1 is used for cleaning the wheels of cars and SUVs. Currently, the Russian market presents many models of plants dyal wheel wash, both domestic and foreign manufacturers. From overseas is worth noting wheel wash Trommelberg, Drester, Wulkan. MK-1 is a strong competitor. Wheel wash MK-1 is much cheaper than their counterparts, as done in Russia. In addition, MK-1 features a lack of sophisticated electronics and mechanical method of timing wheel wash, which simplifies management. Wash stainless steel chamber, a convenient location of units and domestic components make the MK-1, a convenient and inexpensive to repair. A small footprint install wheel wash MK-1 can place it in virtually any room.
